Xerox VersaLink C7020 C7025 C7030 C7000 Printer Boot Menu
Purpose
To start the device in various modes to enable special functions.
Procedure
1. Switch off the machine.
2. Simultaneously press then hold down the Home and Power buttons until the device powers on and SPECIAL BOOT MENU appears.
3. Simultaneously touch the letters A in SPECIAL, B in BOOT and the Home button. Do not hold any of the three locations, just touch/press then release simultaneously.
4. At the keypad screen enter code number, 6789#. The first SPECIAL BOOT MENU screen will display.
CAUTION: Do not switch off the device until the reboot is complete. The device will reboot after the download is complete.
5. Scroll through the SPECIAL BOOT MENU screens to select the appropriate function, refer to Table 1. Follow the on screen instructions. The device may reboot, then print a report.
Table 1 Next level of menu
Function | Display | Notes |
DOWNLOAD MODE | –BOOT MODE– DOWNLOAD MODE ARE YOU SURE? YES NO | Machine starts in Firmware Download Mode. |
LONGDIAG MODE | –BOOT MODE– LONGDIAG MODE ARE YOU SURE? YES NO | Performs a more detailed check than the usual device diagnostic items at machine start. If a fault code is displayed, perform the relevant procedure. |
01. JOB LOG CLEAR MODE | –BOOT MODE– 01. JOB LOG CLEAR MODE ARE YOU SURE? YES NO | Used to clear corrupted jobs. |
02. FACTORY INIT MODE | –BOOT MODE– 02. FACTORY INIT MODE ARE YOU SURE? YES NO | CAUTION: Do not perform this mode unless directed. Machine will be reset and the message NVMEM IS CLEARED will be displayed. Switch the machine off, then on, GP 10. Fault code 116-334 will be displayed, again switch the machine off, then on, GP 10. Fault code 124-315 will be displayed, perform dC132 The machine will restart at the install wizard. CAUTION: All customer configured settings will be deleted. To restore the customer configured settings, a clone file is required. Refer to GP 13. NOTE: The install dongle will not be required. |
03. NVRAM INIT MODE | -BOOT MODE– 03. NVRAM INIT MODE ARE YOU SURE? YES NO | Forcibly initializes the controller NVM back to default. This is the same as initializing the Sys – System NVM and Sys – User NVM in dC301. |
04. HDD FORMAT MODE | -BOOT MODE– 04. HDD FORMAT MODE ARE YOU SURE? YES NO | All pending jobs will be deleted. The HDD will be forcibly reformatted. CAUTION: All customer data on the HDD (mailboxes, scanned documents, user IDs and account IDs) will be deleted. |
06. HDD INITIALIZE MODE | –BOOT MODE– 06. HDD INITIALIZE MODE ARE YOU SURE? YES NO | All pending jobs will be deleted. The spool area of the HDD will be initialized. CAUTION: All customer data on the HDD (mailboxes, scanned documents, user IDs and account IDs) will be deleted. |
SKIP INSTALL WIZARD | –BOOT MODE– SKIP INSTALL WIZARD ARE YOU SURE? YES NO | Starts the machine without displaying the install wizard. |